…and almost none of it spent in the shed, but for once that wasn’t a bad thing 🙂
(I know this might be confusing if you’re reading this outside Ireland, but check the international news, we wound up in it almost everywhere). Herself was canvassing and leafletting and doing her part for this for the last few weeks, and we were all a bit on edge throughout because the No campaign were being violent and abusive and just plain nasty in an attempt to drive down turnout for the vote, but in the end people remembered thirty-five years of suffering and overwhelmingly voted yes. After which, to be frank, we were all a bit weepy and wiped out. Herself went in to Dublin Castle for the official announcement, and I went off with Junior to the grandparents to decompress and grill some hamburgers, and we all went home and crashed that evening with a plan to not even move the next day if we didn’t have to.
But I figured the shed might help me unwind a little so…
First things first, grind a camber onto the new scrub plane…
I’m always convinced this stage is going to ignite six litres of shellac and finishes so I’m not hugely fond of it but needs must…
Then on to the stones to fine tune the bevel and hone it.
Well, that worked…
And a slightly less aggressive camber than Sid’s. So, Sid gets relegated to the toolbox for the foreseeable; he may be dug out again if I ever need to thickness a lot of pine or something like that, but he tended to bite me as much as he’d bite the wood, so I’d rather stick with the new plane, it lets me bleed less on the work which will hopefully improve the final finish of pieces. Happily, I didn’t have to do anything to the mouth, so the guilt of mangling an old but perfectly fine Record #04 wasn’t triggered.
In its new home.
And now my wall is almost 100% record (bar the two stanley block planes and the preston spokeshaves). Which is odd because I didn’t start out looking to make a collection, but I seem to have wound up with one anyway.
Oh well. Time to actually use the sodding things now. I have some rough cut pieces still ready to start in on…
But I’m not actually touching those today, I wanted to get a feel for what beech is like to work so I’m prepping some pieces for a simple box first from the offcut left over from doing those rough cuts.
Ripped the offcut in half and planed to matching width.
Then flattened one side and thicknessed with the new scrub plane. Honestly, this is not my favourite part of this hobby.
And it generates a lot of mess…
But I got the pieces thicknessed and flattened on both sides, and shot the ends square and then cut out 8″ and 5″ lengths for the sides of the box.
…and I don’t like the proportions. Hm. I wanted to use the rippled sycamore for the lid here, so I think I’ll let it dictate the proportions; that should shrink the width by a solid inch here which I think might work. It’ll be a japanese style tool box thing when its done, if a little bit fancier than those normally get made because I want to use pegs instead of nails and try to make it pretty. We’ll see if it works 😀
I’ll probably just futz with the proportions stuff and maybe cut the housing joints here tomorrow, and then I want to get on with the resawing and prep work on the pile of rough cuts for the box, it’s for a present and I’d like to get a start on it. And I’m seriously thinking about taking this Friday off as it’s the June bank holiday weekend and a four day weekend right now sounds almost scandalously luxurious…
Out with the old…
