Just before xmas, I snapped a piece off a rear molar (the tooth was long dead – long story – so there wasn’t any immediate pain), and because of work and stuff, haven’t had time to get it looked at, but then it started on the stabbing pain thing on friday so it was dentist time. Turns out the tooth’s dead but now has an abscess. Yay. So it’s codine and antibiotics for a while, which usually wipes me out. Spent most of the weekend zonked, and not much progress has been made. But there’s been some; the rear side’s slats are now done:
Handy workout for the new shooting board too…
Left a bit of excess at the end of the top crossrail both to have some extra strength in the end pieces and to let me thing of a more decorative way to handle the end grain there.
So, crib progress…
To-Do List (now in new order):
Fit top crossrail to back support and steambent uprights.Cut mortice for back support.Cut back support to length and cut tenon on bottom end.Cut back slats to length and cut tenons.Cut mortices for back slats.- Measure off side slats (because they’re going into a curve, this is going to be fiddly) and cut tenons.
- Cut mortices for side slats.
- Cut grooves for top panel in long stretchers.
- Joint drawer runners into the bottom end crosspieces.
- Thickness the boards for the drawer.
- Cut the drawer front to size.
- Cut the drawer back and sides to size.
- Cut dovetails for drawer.
- Groove drawer with #43 for plywood base.
- Assemble drawer.
- Drill for drawboring on the M&T joints that I’ll be drawboring (the long rail to upright ones and probably the back support and top crossbar joints).
- Make drawbore pegs.
- Finish plane all parts.
- Finish walnut pieces with a few coats of shellac.
- Paint drawer with milk paint.
- Assemble and glue-up and drawboring of everything.
- Finish entire assembly with several coats of Osmo wood wax.
- Close door of shed, lock it, walk away and never do another project with a deadline ever again.
I’m hoping to get a few more of those crossed off before the weekend, like the grooves, and the drawer runner joinery and start finish planing the panels; I want daylight for the side slats, so that might need to wait for the weekend, and I might wind up starting on the drawer before then. But it’s really getting closer now…
Also, got a late xmas gift – a friend is into woodturning in a big way (Hi Tom!), and Claire got him to make me a pen from purpleheart…
Lovely looking piece, the photo doesn’t do the purpleheart justice.
Tags: crib, hand tools, Woodworking
