Realised in the last few days that the delivery date for the cot (hehe, see what I did there?) is six weeks away. Yikes. Need to finish off the stock prepping more quickly. So tonight I got the last three laths and resawed them down to slats using the Tyzack saw to start the cut and taking over with the ryoba after the first six inches or so. This seemed to work quite well and a lot faster than the last few resawing jobs.
I am wondering how I’m going to do the panels in the drawer box at the bottom though. I don’t mind thicknessing them down by a quarter-inch or so (with a scrub plane that’s about three minutes of work), and I suppose the weight at the base will add to stability which is a plus. Some thought required. Meanwhile, on with prepping the slat blanks. Out with the thicknessing jig and got one down to thickness after a quick stropping of the jack and smoother plane blades (the new higher angle on the smoother plane works brilliantly on the ash, I’m seriously thinking about adding a back bevel to it just to increase the angle even more now).
Only got through one slat though, and had to plane a good three mm off the edge so there’s ample room on all of these to get them down to size. I think I’ll get all 8 readily from these (I’m counting that as improving 😀 ). That gives me a total of 27 slats, so I’ll do 13 to a side and have one spare. I should have these all finished by Friday, and I plan to get the steaming jig built over the weekend as well as run the power cable out to the shed, and then next week it’ll be prepping frame and panel pieces and the following weekend I can do some steambending. That gives me four more weeks and a few days to get the joinery, assembly, fitting and finishing all done. It’s doable, but I’m going to have to start mucking about with finish testing soon as well or I’ll wind up messing up at the far end.
Nothing like a nice relaxing hobby to take your mind off work deadlines 😀
Tags: crib, hand tools, resawing, tools, Woodworking
[…] to then smooth the surface I resorted to my #04½ because I ground that thing with a higher angle a while back and put a back bevel on the iron. And even with it set to a whisper thin cut and skewing the […]